Welcome!

This support forum is for customers of our ink and toner cartridges and refills.

Hide Intro

HP 932 / 933 / 950 / 951 refill instructions

on 4/1/20, 12:29 PM • 526 views

1. Locate the “Fill Port” on your cartridge.

2. You should see a plastic ball in this “Fill Port”. Use a allen wrench, or a small screw driver

with a hammer, to gently knock the plastic ball into the cartridge.

3. Connect the needle to the syringe and fill with ink.

4. Inject about 10-15 ml. of ink into the filling hole or until the ink chamber is full. Be sure

to leave enough room in the ink chamber for the new plug, it will create pressure when

inserted.

5. Seal the hole. Make sure the seal is air tight. If your plug is sticking out to much, cut it

down to size and use electrical or duct tape to help secure the plug in place.

6. Rinse the syringe with water and dry for future use, or use with a different color ink.

7. Reinsert the cartridge and run a priming cycle as per printer instructions.

Note: You may want to refer to your printer manual to turn off usage information. This

allows you to continue using your newly refilled cartridge.

See instructions and images here: www.uni-kit.com/support.htm

This is a support forum for ink and toner cartridges and refills. Read Guidelines

1 follower(s)